|
|
1999 Chevy Camaro SS - Bait & Hook
|
|
| Data File 1999 Camaro SS |
| Owner: | Tommy Herrschaft |
| Block: | LS3, 416 cid |
| Compression ratio: | 11.5:1 |
| Heads: | TEA/TrickFlow 215cc, 2.02 intake, 1.575 exhaust valves |
| Cam: | Comp Cams hydraulic roller, 247/254 duration at 0.050, 0.623/0.623-inch lift, 114 LSA |
| Rocker arms: | Harland Sharp, 1.7 ratio |
| Pistons: | Manley, forged |
| Rings: | Sealed Power |
| Crankshaft: | Callies Compstar, forged |
| Rods: | Callies Compstar, forged |
| Throttle body: | Nick Williams 90mm |
| Fuel injectors: | 42 lb/hr |
| Fuel pump: | Racetronix 255 lph |
| Ignition: | Stock, coil-near-plug |
| Engine management: | Stock, tuned by Justin Nelson
| | Power Adder: | Nitrous Outlet 90mm Plate, 200-hp, single stage |
| Exhaust system: | QTP 1.75-inch long-tube headers, custom off-road Y-pipe, SLP dual/dual exhaust with Corsa tips |
| Transmission: | T56, built by Justin Nelson |
| Clutch: | Mcleod RXT |
| Driveshaft: | Strange 3-inch chrome-moly |
| Front suspension: | QA1 R-series coil-overs, SLP sway bar, stock control arm |
| Rear suspension: | BMR torque arm, lower control arms, Panhard bar, Eibach springs, stock shocks |
| Rearend: | Strange S60, 4.10 gear, 35-spline axles, Power Lock posi |
| Brakes: | Power Slot rotors, Hawk pads |
| Wheels: | SLP SS 17x9.5 front, GM Grand Sport 17x11 rear (street); Greg Weld 15x3.5 front, 15x10 rear (track) |
| Front tires: | BFG KD 275/40/17 (street), M/T ET Fronts 26x4.5-15 (track) |
| Rear tires: | BFG KD 315/35/17 (street), M/T ET Drags 28x10.5-15 (track) |
| Fuel Octane: | 93/117 |
| ET/MPH: | 9.91/140 |
| 60-Foot: | 1.44 |
| Current mileage: | 37,000 |
|
|
|
|
|
|
|
1999 Chevy Camaro SS - Street Heat
Clint and Stacceye Stallard, a couple stationed at Randolph Air Force Base in San Antonio, Texas, are the proud owners of this rare '99 Hugger Orange SS Camaro....
more
|
|
|
|
|
|
|
|
|
|
|
|
1998 Chevy Camaro SS - Street Heat
Yes, people at GM do hang out on Internet message boards and Steve Bone is one of them. As a design engineer at the GM Design Center, Steve has had a hand in the development and evolution of both the...
more
|
|
|
|
|
|
|
|
|
|
|
|
|
|