GMHighTechPerformance Homepage

0211gmhtp Spdelivery12 Zoom

The Nu-Tek cylinder honing machine rocks! A lot of shops that don't have a sophisticated honing machine will actually finish a cylinder with the boring machine to about 1.5 thousandths because it is so hard to hone, but this honing machine will take as much as 5 thousandths out in a matter of minutes with diamond saws. It varies in speed while cutting on the up and down stroke to maintain a consistent bore diameter and an exact cross-hatch pattern.
LT1 Stroked Crate Motor Specifications - Special Delivery

 The Nu-Tek cylinder honing machine rocks! A lot of shops that don't have a sophisticated honing machine will actually finish a cylinder with the boring machine to about 1.5 thousandths because it is so hard to hone, but this honing machine will take as much as 5 thousandths out in a matter of minutes with diamond saws. It varies in speed while cutting on the up and down stroke to maintain a consistent bore diameter and an exact cross-hatch pattern.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide