0407htp Trans 50 Z

An original front U-joint had seen better days, and the rear U-joint had a limited range of movement, so I decided to replace both. Mike used a torch to melt the injected nylon holding the joints--if you do this yourself, just heat the nylon up enough to get it out. Sometimes they'll go flying if they get too hot. Replacement GMB U-joints were installed.

TH200-4R Rebuild - No Nonsense 900

An original front U-joint had seen better days, and the rear U-joint had a limited range of movement, so I decided to replace both. Mike used a torch to melt the injected nylon holding the joints--if you do this yourself, just heat the nylon up enough to get it out. Sometimes they'll go flying if they get too hot. Replacement GMB U-joints were installed. View Related Article