GMHighTechPerformance Homepage

0410htp Efi 37 Z

Aeroquip -6 AN is used from the fuel pump to the rail, and from the rail back to the tank. Once the hose length was determined, Bill Hahn uses a chop saw to cut the hoses, flushes them out with solvent, and uses a liberal amount of engine oil inside them and on the fittings for final assembly. When they were ready to go, the lines were run and secured at the factory mounting points with clamps.
Accel DFI Conversion - 21st Century Digital Toy

 Aeroquip -6 AN is used from the fuel pump to the rail, and from the rail back to the tank. Once the hose length was determined, Bill Hahn uses a chop saw to cut the hoses, flushes them out with solvent, and uses a liberal amount of engine oil inside them and on the fittings for final assembly. When they were ready to go, the lines were run and secured at the factory mounting points with clamps.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide