GMHighTechPerformance Homepage

Ls1 Engine Build Rocker Stand

Now, the billet steel Jesel rocker stand is bolted to the cylinder head. The supplied 8mm bolts thread into the same holes (helicoiled by ETP) where rocker studs would normally go, making the Jesel shaft rocker system a true bolt-on piece. Before putting the stand in place, you might want to re-torque your head bolts or studs one last time (it should be done a few times as the gasket slowly seats); once installed, the rocker stand will obstruct access to some of them.
My First Stroker Part 3 - LS1 Engine Build

 Now, the billet steel Jesel rocker stand is bolted to the cylinder head. The supplied 8mm bolts thread into the same holes (helicoiled by ETP) where rocker studs would normally go, making the Jesel shaft rocker system a true bolt-on piece. Before putting the stand in place, you might want to re-torque your head bolts or studs one last time (it should be done a few times as the gasket slowly seats); once installed, the rocker stand will obstruct access to some of them.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide