|
With the coils in place, we install new NGK spark plugs (since this is a new head, they'll get 15 lb-ft of torque) and pop on our MSD wires, being sure to use adequate dielectric grease on each end. We'll of course have to disconnect the wires from the plugs to get our headers to go on, but you can see here how these wires are more than long enough to reach the plugs. The plug end of each boot is also bendable to just about any angle, which helps orient the wire to clear all exhaust header primaries and other obstructions-a very nice feature. View Related Article
|
|