GMHighTechPerformance Homepage

1994 Pontiac Trans Am

...I decided to leave well enough alone and button up the rest of the install. After Junior removed the crank snout from the stock crank pulley via a 20-ton press, it was reinstalled onto the crank with the installer tool. The March pulley was then bolted down with a 5/8-inch socket, Loctite, and 60-80 ft-lbs of torque. In case you are wondering about the plug wires, Junior went to great lengths to make sure they were plenty guarded (with Accel heat sleeves) from the scorching hot header primaries. Since these will have to come off the car anyway, we are going to skip over this.
1994 Pontiac Trans Am - When LT1s Attack: Part II

 ...I decided to leave well enough alone and button up the rest of the install. After Junior removed the crank snout from the stock crank pulley via a 20-ton press, it was reinstalled onto the crank with the installer tool. The March pulley was then bolted down with a 5/8-inch socket, Loctite, and 60-80 ft-lbs of torque. In case you are wondering about the plug wires, Junior went to great lengths to make sure they were plenty guarded (with Accel heat sleeves) from the scorching hot header primaries. Since these will have to come off the car anyway, we are going to skip over this.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide