|
The new Spec flywheel goes in. Torque using GM's step-up sequence and specifications to a final 74 lb-ft, and be sure to use red threadlocker. You'll have to hold the flywheel from turning here, too. Note the yellow paint mark in the bottom right of the flywheel, which we will line up with a corresponding mark on the pressure plate when it's installed. You can substitute an aluminum flywheel in this system to save about 10 pounds in mass, but we took the steel to be more stop-and-go traffic-friendly (though the aluminum version is said to be quite driveable, too). View Related Article
|
|