GMHighTechPerformance Homepage

1996 Ta Install

Installation of the new suspension components begins by disconnecting the negative lead on the battery, and getting the car elevated on a lift. Typical installation labor is generally around 8 hours on a stock-type suspension with an aftermarket rear. Both shop labor and technical assistance is $70 per hour. The driveshaft is then removed by unbolting the four 3/8-inch nuts and U-bolt clamps, holding the U-joint to the rearend yoke with a 9/16-inch wrench. Once removed, the U-joint bearing caps are taped in place, and the driveshaft is carefully slipped back out of the transmission tailshaft and stored.
1996 Pontiac Trans Am - Mad ETS - Tech

 Installation of the new suspension components begins by disconnecting the negative lead on the battery, and getting the car elevated on a lift. Typical installation labor is generally around 8 hours on a stock-type suspension with an aftermarket rear. Both shop labor and technical assistance is $70 per hour. The driveshaft is then removed by unbolting the four 3/8-inch nuts and U-bolt clamps, holding the U-joint to the rearend yoke with a 9/16-inch wrench. Once removed, the U-joint bearing caps are taped in place, and the driveshaft is carefully slipped back out of the transmission tailshaft and stored.  View Related Article

 

 

Get Adobe Flash player

Car Research Guide